Waters 2545 Binary Gradient Module User Manual

Replacing the vent valve rotor-seal assembly 3-27
2. Use a flat-blade screwdriver to remove the fuse holder, which is located
below the power entry module.
Removing fuses
3. Replace both fuses with fuses of the appropriate type, and reinsert them
into the holder.
4. Reinstall the fuse holder in its receptacle in the rear panel.
5. Connect the power cord to the power entry module.
Caution: For continued protection against fire hazard, replace fuses
with the appropriate type and rating.
!

Waters 2545 Binary Gradient Module Specifications

General

Brand	Waters
Model	2545 Binary Gradient Module
Category	Control Unit
Language	English