vii
Operating this instrument
When operating this instrument, follow standard quality-control (QC)
procedures and the guidelines presented in this section.
Applicable symbols
Intended use
Waters designed the Single Quad (3100) Detector for use as a research tool to
deliver authenticated mass measurement in MS mode. The Single Quad
(3100) Detector is for research use only and is not intended for use in
diagnostic applications.
Calibrating
To calibrate LC systems, follow acceptable calibration methods using at least
five standards to generate a standard curve. The concentration range for
standards must cover the entire range of quality-control samples, typical
specimens, and atypical specimens.
Symbol Definition
Manufacturer
Authorized representative of the European
Community
Confirms that a manufactured product complies
with all applicable European Community
directives
Australia C-Tick EMC Compliant
Confirms that a manufactured product complies
with all applicable United States and Canadian
safety requirements
Consult instructions for use
To Next Page
Loading...
