B-2 Specifications
Program storage Storage for sets of 15 tables (Gradient, Event, and
Detector), with up to 15 steps per table.
Storage for a time-based multimethod program with
up to 48 individual steps, linking sets of tables.
EEPROM stores setup parameters and tables and
preserves memory indefinitely following power loss or
extended shutdown.
Gradient profiles Eleven gradient curves (including linear, step,
concave, and convex).
Keyboard Dedicated keys provide direct access to all display
screens. Cursor movement keys simplify
programming, editing, and parameter entering. All
keys are solvent resistant.
Programmable
timed events
Fifteen timed events can be programmed and stored
for each table:
• Set S1 to S4 for accessory control
• Audible alarm
•Set sparge rate
• Return to initial conditions
• Change to new Gradient table
Electrical specifications
Item Specification
Power
requirements
Maximum power 500 VA
Power consumption 350 watts
Frequency 50 or 60 Hz
Fuse Nominal Voltage Fuse (Amp)
100, 120 4 Amps
220, 240 2 Amps
Pump power fuse 4 A, 125 VAC, IEC (Time Delay) 5 × 20 mm. Protects
the pump from excessive current loads.
Operational specifications (Continued)
Item Specification
To Next Page
Loading...
