Watlow F4T Install & Troubleshooting • 54 • Chapter 6 Appendix
Declaration of Conformity
Series F4T
WATLOW Electric Manufacturing Company ISO 9001since 1996.
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following products:
Designation:
Series F4T ¼ DIN Control
Model Numbers: F4T X X (1 to 8)
X AA XX X
XXX X = any number or letter.
Classification: Process Controller Base Installation Category II,
rated IP65 or IP40 if flush mount option is used.
Rated Voltage and Frequency: High Voltage 100
240 Vac 50/60 Hz, F4TXX(1, 2, 3, 4)
Low Voltage 24 – 28 Vac/dc 50/60 Hz, F4TXX(5, 6, 7, 8)
Rated Power Consumption: Up to 23 Watts with six modules loaded.
Only the front display is considered part of the ultimate enclosure, the unit is considered an open type
process control, it requires an ultimate enclosure and at least one Watlow EZ-ZONE
®
FM “Flex Module” to have a
useful function. All Flex Modules were tested as part of F4T system for compliance with the following directives.
2004/108/EC Electromagnetic Compatibility Directive
EN 61326-1
EN 55011
2013
2010
Electrical equipment for measurement, control and laboratory use – EMC
requirements (Industrial Immunity, Group 1 Class A
1
Emissions).
EN 61000-4-2 2009 Electrostatic Discharge Immunity
EN 61000-4-3 2010 Radiated Field Immunity
EN 61000-4-4 2012 Electrical Fast-Transient / Burst Immunity
EN 61000-4-5 2006 Surge Immunity
EN 61000-4-6 2009 Conducted Immunity
EN 61000-4-11 2004 Voltage Dips, Short Interruptions and Voltage Variations Immunity
EN 61000-3-2 2009 Harmonic Current Emissions
EN 61000-3-3
2
2013 Voltage Fluctuations and Flicker
SEMI F47 2000 Specification for Semiconductor Sag Immunity Figure R1-1
1
NOTE: Not for use in Commercial or Residential locations without additional emissions protection.
2
NOTE: To comply with flicker requirements cycle time may need to be up to 160 seconds if load current is at 15A, or the
maximum source impedance needs to be < 0.13
. Unit power of F4T model complies with 61000-3-3 requirements.
2006/95/EC Low-Voltage Directive
EN 61010-1 2010 Safety Requirements of electrical equipment for measurement, control
and laboratory use. Part 1: General requirements
Compliant with 2011/65/EC RoHS2 Directive
Per 2002/96/EC W.E.E.E Directive and 2006-66-EC Battery Directive Please Recycle Properly.
Joe Millanes Winona, Minnesota, USA
Place of Issue
Name of Authorized Representative
Director of Operations
July 2014
Title of Authorized Representative Date of Issue
Signature of Authorized Representative
Anderson-Bolds ~ 216-360-9800
To Next Page
Loading...
