Watlow F4T - Flex Module - High Density Ordering Information; Flex Module - Communications Ordering Information

Watlow F4T Install & Troubleshooting • 53 • Chapter 6 Appendix
Flex Module - High Density Ordering Information
Part Number
① ② ③
Module
ID Type
④
Future
Option
-
⑤
Input and
Output
Hardware
⑥ ⑦ ⑧
Future
Option
-
⑨
Future
Options
⑩
Custom
Options and
Connectors
⑪ d
Custom Options - Firmware,
Overlay, Preset Parameters,
Locked Code
FM H A AAA A
③ Module Type
H = High Density I/O
⑤ Input and Output Hardware
R = 4 universal inputs (T/C, RTD 2-wire, 0-10VDC, 0-20mA)
P = 4 thermistor inputs
C = 6 digital I/O
F = 3 universal process/retransmit outputs
B =
3 mechanical relay 5A, 2 Form C and 1 Form A (Form A
shares a common with one Form C)
J = 4 mechanical relay 5A, Form A
K = 2 SSRs 10A
L =
4 SSRs at 2A each. SSRs grouped in 2 pairs with each pair
sharing a common
Flex Module - Communications Ordering Information
Part Number
① ② ③
Module
ID Type
④
Future
Option
-
⑤
Comm.
Option
⑥ ⑦ ⑧
Future
Option
-
⑨
Future
Options
⑩
Custom
Options and
Connectors
⑪ d
Custom Options - Firmware,
Overlay, Preset Parameters,
Locked Code
FM C A 2 A A
⑤ Communication Option
2 = Modbus
®
RTU 232/485*
⑩ Custom Options and Connectors
A = Right angle screw connector (standard)
F = Front screw connector
⑪ d Custom Options - Firmware, Overlay,
Preset Parameters, Locked Code
AA = Standard with quick start guide
AB = Standard without quick start guide
AC = Replacement connectors hardware only - for the
entered model number
XX = Custom
Anderson-Bolds ~ 216-360-9800
www.anderson-bolds.com