Byte 26 Header
Byte 27 Channel type
Byte 28 Channel-related error code
Channel-related diagnostic data Byte 3
Global error =0xA9 (General error)
Over current =0xA1 (Short circuit)
Under voltage =0xA2 (Under voltage)
Over voltage =0xA3 (Over voltage) =0xA3 (Over voltage)
Motor stall =0xA4 (Overload)
Over temp =0xA5 (Over temp) =0xA5 (Over temp)
Tacho fault =0xB1 (Device related 0x11)
Leak detected =0xB2 (Device related 0x12)
Fluid level alert =0xB3 (Device related 0x15)
Reserved =0xA6 (Reserved)
Setpoint out of range- high =0xA7 (Upper limit exceeded)
Setpoint out of range- low =0xA8 (Lower limit exceeded)
m-qdos-en-02 63
To Next Page
Loading...
