7. BATTERY information
7.1. General information
The SMP3 includes a rechargeable Li-ion battery allowing the device to run up
to 24 hours (in selective mode that time is reduced to about 10 hours). You
can check the battery charge level at any time in the upper right-hand corner
of the main screen.
Li-ion batteries have no “memory effect” and so there is no need to let
the battery run down completely. We recommend charging the battery
completely before its first use.
• Always switch the device off when it is not in use.
• Recharge the battery regularly (e.g. every 2 months) even if the device
goes for long periods with no use.
The battery of the SMP3 should be recharged when the indicator
shows the minimum level.
Measurements should be taken without the charger or the USB
connected, to avoid any alteration of the results.
The battery will function normally at temperatures between -10ºC and +
50ºC. However, we recommend avoiding low temperatures to prevent its
useful life from being shortened.
We recommend using only the battery charger supplied by Wavecontrol
to recharge the battery of the SMP3.
To Next Page
Loading...
