8.3.1 Measurements screen
Measurements are loaded automatically when the SMP3 is connected by
USB. A list will appear on the left with the measurements stored in the SMP3.
When you select a measurement, a table and a graph will appear on the right
with all the field samples taken. A window will open to the left of the table with
general information on the measurement. This window includes a button for
direct access to the screenshots associated with the measurement. With an
Internet connection, a map will also appear with a position indicator if the GPS
was switched on during the measurement.
If you select a sample from the table, the program will trace a vertical red line
in the graph, and if you click on a point in the graph, the vertical line will move
to the position of the cursor and the corresponding sample will be
highlighted in the table. You can use this to find maximum values, ordering
samples by value, by clicking on the Field heading.
Note: If the GPS was switched on during the measurements, the position data will
also appear in the table.
Figure 10: SMP3 Reader software measurement screen
To Next Page
Loading...
