General Power Tool Safety Warning
Read all safety warnings, instructions, illustrations and specifications provided
with this water jet cutter. Failure to follow all instructions listed below may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Work area safety
•
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
• Set up and operate the water jet cutter where the floor surface and surrounding area are
water resistant and slip resistant. Water is likely to spill during routine use, set up and
maintenance of water jet cutters. Wet floor surfaces may increase the risk of slip and fall
which can result in serious personal injury.
• Water jet cutters must be operated only by persons familiar with their operation and
manufacturer’s instructions. Operation of water jet cutters by persons unfamiliar with their
operation and manufacturer’s instructions can result in electric shock, fire and/or serious
injury.
• Keep children and bystanders away from the water jet cutter while it is operating, and do
not allow unsupervised children and bystanders to interact with the water jet cutter at any
time. Other people in the work area may cause distractions, and persons unfamiliar with the
operation of the water jet cutter may change its setup, which may increase the risk of electric
shock, fire and/or serious injury.
Electrical safety
•
Before using the water jet cutter, test all Ground Fault Circuit Interrupter (GFCI), Portable
Residual Current Device (PRCD), or Residual Current Circuit Breaker with Over Current
Protection (RCBO) provided to ensure they are operating correctly. A properly operating
GFCI/PRCD/RCBO reduces the risk of electrical shock.
• Do not use the water jet cutter with extension cords. The GFCI/PRCD/RCBO on the machine
power cord will not prevent electrical shock from the extension cords.
• Water jet cutter plugs must match the outlet. Never modify the plug in any way. Do not use
any adapter plugs with earthed (grounded) water jet cutters. Unmodified plugs and matching
outlets will reduce risk of electric shock.
• Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the water jet
cutter. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled
cords increase the risk of electric shock.
• While operating the water jet cutter, avoid body contact with earthed or grounded surfaces
such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock
if your body is earthed or grounded.
• Before every operation of a water jet cutter, make sure that the water connections and water
piping and joints are leak-free. Water leaks may increase the risk of electric shock.
• Because the electronics will be operating around water, both power cables have integrated
GFCI/PRCD/RCBO protection. Do not attempt to use any cables that are not GFCI/PRCD/
RCBO protected.
• DO NOT attempt to use any other Power Supply other than the one included by WAZER
• The replacement of the Power Cables and Power Supply shall only be carried out by the
manufacturer or approved service organization.
Personal safety
•
Stay alert, watch what you are doing and use common sense when operating a water jet
cutter. Do not use water jet cutter while you are tired or under the influence of drugs,
alcohol or medication. A moment of inattention while operating Water jet may result in
serious personal injury.
• Use personal protective equipment. Always wear eye protection. Protective equipment
such as safety glasses, non-skid safety shoes, waterproof gloves and hearing protection will
reduce personal injuries.
Safety |
SECTION 2
9
To Next Page
Loading...