Water Connections
WAZER Pro needs to be plumbed into your water lines.
Installation has 2 steps:
• Hose 1: Water Inlet Hose (3/8” diameter White Hose)
• Hose 2: Water Drain Hose (1/2” diameter White Hose)
Each hose is critical for operation. The Water Inlet Hose provides water for cutting. The Water
Drain Hose disposes water. There are also several connections that cover other essential
functions.
Keep the WAZER Pro away from the wall for 2 feet (0.5m) during this step
If you are uncomfortable with this part of the setup, have a professional plumber
complete this part of the installation for you.
WAZER Pro should never be configured to have its drain water recirculate into its
Water Inlet Hose. This will destroy the Pump and void your warranty.
Note 4 Pg.17
Note 3 Pg.17
Setting Up WAZER |
SECTION 4
Setting Up WAZER Pro |
SECTION 4
33
To Next Page
Loading...