• Never cut any unknown or toxic materials and properly dispose of waste products. Always
refer to the Safety Data Sheet (SDS) from the material manufacturer to determine if it is safe
to return water contaminated by cut material to the water system. Follow local regulations
to properly dispose of all waste products including water, spent abrasive and cut material
debris.
• Keep the interior of the water jet cutter, clean and free of debris. Clean the cutting head and
abrasive supply hose. A build-up of cutting and engraving residue and debris is dangerous
and may increase the risk of improper performance or an environmental hazard such as
clogging, overflowing, and jamming.
WAZER Safety Precautions
In addition to the “General Power Tool Safety Warnings” in the previous section
we have outlined a set of WAZER specific safety precautions. In general, this entire User Manual is
filled with important safety information – please read it carefully and ensure that anyone that uses
WAZER Pro has read this User Manual as well. Before setting up and using WAZER Pro, read and
follow all instructions and safety messages. ALWAYS be aware of and comply with all federal, state,
and local safety regulations, industry standards, and internal company safety guidelines.
Environment and Machine Location
•
WAZER Pro operators should ensure anyone within 10 feet of the Machine follows the
proper safety precautions.
• WAZER Pro should be installed in an area that allows the machine to be monitored while
cutting.
Usage
•
WAZER Pro can cause serious injuries from the high pressure water jet or trapped pressure
in hoselines. It should be accessible only to those that have read this User Manual and are
capable of understanding the risks associated with this tool. Ensure the WAZER Pro location
will never result in an untrained individual using the machine.
• If WAZER Pro is intended to be used by multiple people, put an orientation and training
program in place at the facility to ensure correct usage.
• Do not setup, operate, or perform maintenance on the machine under the influence of illicit
drugs, alcohol, or over-the-counter and prescription drugs that can impair one’s ability to
operate heavy machinery safely.
• All operators of WAZER Pro must be aware of the Power Switch, On/Off Valve, and water
shutoff locations.
• Do not use WAZER Pro or its components in any manner or for any other purpose other
than as specifically instructed in this User Manual.
• Do not modify WAZER Pro or its components.
• Never leave WAZER Pro unattended while in operation.
• All operators of WAZER Pro must follow the safety precautions outlined in the Safety Data
Sheet of WAZER approved Abrasive.
• Use of non-WAZER approved Abrasive may result in equipment or property damage as well
as personal injury.
• All operators must follow the safety precautions outlined in the Safety Data Sheets for the
materials cut on WAZER Pro.
• Always follow the correct startup, operating, and shutdown procedures outlined in this User
Manual.
Safety |
SECTION 2
11
To Next Page
Loading...