Setup
•
Always use proper lifting techniques when lifting heavy components to avoid injury or strain.
• Always make sure the machine is secured using the Wall Mount Bracket.
• Ensure WAZER Pro is plugged into a properly grounded pronged receptacle. Refer to a licensed and
qualified electrician and your local national, state, and local codes if you have any questions. Never
modify the plug.
• Receptacles are included with your unit but should be installed *only* by a licensed electrician.
Failure to do so may result in electrocution and serious injury.
• Only operate WAZER Pro on designated power supply. This may be 230V/60Hz or 230v/50Hz
depending on which model you purchased. Never attempt to operate it using converters or
adapters. Always keep your work area clean.
Operation
•
Never operate WAZER Pro with components out of place or missing. This includes and is not limited
to the Cut Bed, Nozzle Cover, Nozzle, Door Window, safety guards, safety sensors and interlock
systems.
• Never override any safety sensors or systems in WAZER Pro.
• Never touch components inside the Enclosure if WAZER is operating. This includes, but is not limited
to, the Cut Bed, Nozzle, the Material you are cutting, moving parts, hydraulic and electrical parts
• Stay clear of all high-pressure components during operation.
• Never reach under, over, or into WAZER Pro during operation.
• Never place hands under the Cutting Head of the machine. This includes while the machine is in
the turned off state.
• Risk of injury due to accidental starting, keep children away from WAZER while it is running
• Never leave the machine unattended in the paused or any state of being on. If you must leave the
vicinity of the machine be sure to perform the appropriate shutdown procedure for your machine
prior to leaving the area.
Shutdown
•
Always disconnect WAZER Pro from power and shut off the water supply when leaving WAZER Pro
unattended.
Maintenance
•
Follow all maintenance procedures and schedules presented in the online User Manual. Failure to
maintain WAZER Pro could result in damage to the machine, a degradation of cut quality, or create
safety risks to you and your environment.
• Do not engage in any maintenance while WAZER Pro is connected to power and water supply.
Always purge trapped pressure, disconnect WAZER Pro from all power sources and water sources
before interacting with any electronics. Residual pressure in hoselines can cause serious injuries.
• Do not perform unauthorized maintenance on WAZER Pro or its components. All maintenance must
follow instructions in authorized sources of information including this User Manual, WAZER support
site, and content proved by WAZER Customer Support.
Leaks
•
Before and after a Cut, always inspect the surrounding area of WAZER Pro for leaks.
• In the event that a leak is observed, turn off the power going to WAZER Pro, wipe it down, and LET
IT DRY OVERNIGHT before seeing if anything was damaged and is still working. Water doesn’t
damage electronics, it’s the combination of water with running electricity that does; letting them air
dry ensures the next turn on won’t destroy something.
• Never attempt to identify the location of a leak when the machine is under operation or in powered
state. Always purge trapped pressure and shut off water supply first.
12
To Next Page
Loading...