Wazer Pro - Cutting with WAZER Checklist

NEVER skip any Startup or Shutdown steps. Failure to complete these steps
could lead to injury, damage to WAZER Pro and your property.
We suggest you take this page out of the User Manual and leave it near your WAZER Pro.
Cutting with WAZER Pro Checklist
1. Preparation
 Wear proper Personal Protective
Equipment
 Open the On/Off Valve
 Fill the Tank
 Once dry, brush away used abrasive
on door window, bellows, and side
of tank
 Level the Cut Bed
 Check Water Drain Hose Location
and Attachment
 Check for Leaks
 Confirm all Electrical Connections
(Check GFCI/PRCD/RCBO functions)
 Check Position the Water Alarms
2. Cut Setup
 Insert the SD Card
 Turn on WAZER Pro
 Select the File to Cut
 Follow the Control Panel Prompts
- Lift the Nozzle
- Home WAZER
- Load Abrasive
- Empty the Used Abrasive Buckets
- Confirm the Water Supply is On
- Fasten the Material
- Set the Nozzle Height
- Check Cut Extents & Dry Run
- Shut door
3. Cutting
 Listen for the sound of piercing
through the material
 Check the pressure gauge reading
 Pay attention to the following
- Pop-Ups
- Abrasive Clogs
- Partial Cutting
- Leaks
- Abnormal sounds
4. Shutdown
 Run Tank Cleaning Cycle
 Check condition of O-ring, and re-
seat hose end into cutting head
 Close the On/Off Valve
 Turn WAZER Pro Off
 Empty the Used Abrasive bin
 Leave the Door Open
REMOVE PAGE &
KEEP AVAILABLE
CLOSE TO YOUR
WAZER