Wazer Pro - Common Things to be Mindful of During Cutting

Common Things To Be Mindful Of During Cutting
Follow all Safety Advisories when performing a Cut:
• ALWAYS wear eye protection.
• NEVER leave WAZER Pro unattended while in operation.
• ALWAYS know how to press the E stop to turn off WAZER Pro.
• ALWAYS know how to quickly turn off water and power to WAZER Pro.
Pay Attention!
It is important to monitor WAZER Pro while it is cutting. Some issues may require intervention to
avoid damaging WAZER Pro, Cut Material or your property.
Pop-Ups:
Pop-Ups are when a section of material pops up above the original surface of the Material. An edge
may come into contact with the Nozzle, resulting in the Gantry jam and abrasive clog.
Abrasive Clogs:
Abrasive Clogs can sometimes occur, preventing Abrasive from flowing into the Nozzle. WAZER Pro
will stop cutting through the Material. There will be a significant change in the sound of WAZER Pro’s
operation. If there is an Abrasive Clog, press Start/Stop immediately. Refer to the website support
section for more information.
Leaks:
You should monitor for any abnormal drips, leaks or puddles. If you notice this, press Start/Stop
immediately. Exit the cut, turn machine off and trace where the leak originates. Refer to the website
support section for more information.
Expected potential drip areas on WAZER Pro:
• When opening and closing the Door.
• Water may spray through the cracks between the Door and Hoops.
• There may be occasional drips around the Side Windows.
Solution After Leaks Detected:
If there is a leak or things get wet that shouldn’t have, turn everything off, unplug power cord if it
didn’t get wet, wipe the leak, and turn everything off, and LET IT DRY COMPLETELY.
Water Exiting Under the Abrasive Hopper: If you notice water leaking or spraying out of WAZER
Pro from underneath the Abrasive Hopper, press Start/Stop immediately as you have just
experienced a “backflow”. Refer to the online maintenance instruction for more information on
how to resolve this.
56