Full Manual
Creating Cut Files
Maintenance
Cut Rate Testing
The WAZER will cut a series of arcs at increasing speeds to help you determine the cutting
parameters for a new material.
General Cut: Run this cut when you have no idea how fast the WAZER should cut your material.
This test will use the most material and have the least fine resolution.
Fast Cut:
Run this when you know that you material should cut on the faster side.
Medium Cut: Run this when you know that you material should cut in the middle of our range.
Slow Cut:
Run this when you know that you material is going to be slow, typical for materials on
the thicker or harder side.
Machine Info
This feature displays the current firmware version installed in WAZER control unit as well as the
accumulated cut hours.
To Next Page
Loading...