Connecting other devices
VIDEO Output (HDMI) connection
Support HDMI monitor having 1920X1080 and UHD/4K (3840X2016) resolution. Also, NVR can automatically
detect the max resolution of HDMI monitor when the HDMI resolution is set to “UHD/4K (Preferred)”. So, if the
monitor supports only FHD, the video output resolution will be FHD. If the monitor supports UHD/4K, the video
output resolution will be UHD/4K.
Some monitor can be detected as FHD monitor even if the monitor supports UHD/4K. At that case, please set
the NVR’s HDMI resolution as “UHD/4K (Fixed)”.
VGA Monitor connection
VGA output supports main monitor output (HDMI duplicate). The supported resolutions are 800x600, 1024x768,
1280x1024 and 1920x1080. Please check the supported resolution of monitor.
<Note>
Reboot is required when the HDMI resolution is changed
Select the resolution at [Menu – Device – Monitor – HDMI Resolution] and reboot
Changing VGA output resolution
[Menu – Device – Monitor – VGA Resolution] : select resolution of VGA output.
Please reboot after changing completed.
<Caution>
1. Must connect the power cord to the grounded outlet. If not, it may cause electric shock or injury, and may cause the
damage or malfunction of product.
2. It is recommended to use certified HDMI cable. If the cable is not a certified cable, 4K UHD may not be displayed.
(Recommended: HDMI 2.0 certified cable)
3. If HDMI resolution is set to “UHD/4K (Prefered)” and HDMI monitor does not support 3840x2160 (4K UHD), then the
resolution of video output will be automatically changed to 1920x1080. If monitor supports 4K UHD, then the resolution
of video output will be automatically changed to 4K UHD.
Connecting a Camera
Please connect the network cable and register/connect the IP cameras using UI. IP cameras supporting Onvif
Profile-S or WESP can be connected. Also, other DVR (supporting WESP)’s channel can be connected such as an
IP camera.
Connecting a power cord
When power cord is connected, NVR starts booting automatically.
Connecting an audio
RCA cable to connect audio input/output devices to NVR.
Connecting external device
Connecting USB Device
USB port can be used for copy of recorded data and for mouse.
See below table for USB Device specifications.
<Note>
USB memory stick should be formatted as FAT32.
NVR may not recognize USB Flash memories that require additional program on MS Windows.
To Next Page
Loading...