3. INPUTS/OUTPUTS
ANALOGUE INPUTS
• TEMP Input not available
DIGITAL INPUTS
• CVOL Input not available
•
KEY1 Key input not available
•
KEY2 Key input not available
•
KEY3 Key input not available
•
KEY4 Key input not available
SERIAL LINE (RS232)
• TxD / RxD Signals for serial transmission
MAINS VOLTAGE OUTPUTS
• RISC Output not available
POWER SUPPLY
• The card is powered with the nominal mains voltage by means of the appropriate fast-ons
CONNECTIONS
• Power supply FAST-ON (bi-polar plug for countertop version)
• Analogue inputs Included for AMPMODU2
•
Digital inputs AMPMODU2
•
High voltage outputs
Included for FAST-ON
•
Serial connection AMPMODU2 (circular connection for countertop version)
4. SYSTEM SET-UP: MOBILE JUMPERS
ANALOGUE INPUTS
• P1 Available
•
P2 Available
The system configuration jumpers must be set up before the unit is started up.
If the configuration is subsequently modified, the insertion or removal of a jumper must be carried out when the card is not powered. The next
start-up will allow the new function to become operational.
To Next Page
Loading...
Need help?
General
