5. STARTING THE MACHINE
When power is supplied to the device, it comes on and the display shows the message “On”.
In this manner the following functions are enabled:
• Reading of servings performed
• Deletion of servings performed
NOTE
• it is not possible to shut off the device; the KONOFF key, even if connected, is bypassed.
• when power is supplied to the card, for approximately 2 seconds the version of the installed program is shown. E.g.: “V.1.00”.
6. READING AND DELETION FUNCTIONS
The reading and deletion functions are permitted only with the activation key inserted.
To choose the operation to be performed, the KMODE key is used.
By pressing it several times, the available functions are selected one at a time, in the following order:
• Reading of servings performed
• Deletion of servings performed
During any data reading or deletion operation, it is not possible to perform dispensing.
“Insertion of the programming key” is understood to mean closure of the relative contact.
7. SERVING READING (STROKE COUNT)
The number of SERVINGS provided by each single key of each group of connected dosing can be
viewed by means of the following procedure:
• Insert the activation key.
• Press the KMODE key, and the display will show the message “Count”.
• Then, within 30 seconds, press the KENTER key.
The first item of data is shown, which consists of the number of SERVINGS made on the first key of the
first group.
To Next Page
Loading...
Need help?
General
