EMISSIONS
This genset meets the requirements
of
California's Exhaust
Emissions Standards
as
stated
on
the nameplate.
You
should carefully review operator (Owner) Installation
and other manuals and information you receive with your
genset.
If
you are unsure that the installation, use,
maintenance or service
of
your genset is authorized, you
should seek assistance from an approved
WESTERBEKE
dealer.
California users
of
this genset should
be
aware that
unauthorized modifications or replacement
of
fuel, exhaust,
air intake, or speed control system components that affect
engine emissions are prohibited. Unauthorized modification,
removal or replacement
of
the engine label
is
prohibited.
California genset users may use the table below
as
an
aid
in
locating information related to the Califomia Air Resources
Board requirements for emissions control.
Federal Emissions Compliance Period: The Federal
Emissions Compliance Period referred
to
on the nameplate
indicates the number
of
operating hours for which the engine
has been shown
to
meet Federal Emissions requirements.
Catagory C=
250 hrs, B=500 hrs, A
=lOOO.hrs.
EMISSIONS
CONTROL
INFORMATION
TABLE
111e
California emissions control warranty statement is located
in
the same
Emissions
Warranty
Information
packet,
if
information
as
this manual when the genset is shipped from the
factory.
Engine Fuel Requirements
The engine
is
certified to operate on unleaded gasoline. See FUEL
RECOMMENDATIONS.
Engine Valve Adjustment See MAINTENANCE SCHEDULE.
Engine Ignition Timing See MAINTENANCE SCHEDULE.
Engine
Lubricating
Oil Requirements See ENGINE OIL RECOMMENDATIONS.
Engine
Adjustments
ECU.
Engine Emission Contol System
The engine emission control system consists
of
engine design and precision
manufacture.
Catalyst See
MAINTENANCE SCHEDULE.
Oxygen Sensor See MAINTENANCE SCHEDULE.
Back
Pressure
See MAINTENANCE SCHEDULE.
v
To Next Page
Loading...
