INSTALLATION AND MAINTENANCE MANUAL
LYNX E1 FAMILY
LICENSED & SPREAD SPECTRUM RADIOS
JUNE 2001
PAGE 1-2 SECTION 1: HOW TO USE THIS MANUAL
1.2 Icons
Throughout this manual, the following icons are used to highlight areas of special interest and
importance.
Note Practical Tip Caution
1.3 IMPORTANT SAFETY INSTRUCTIONS
This product is intended to be installed, used and maintained by experienced telecommunications
personnel only.
This product has been evaluated to the U.S. and Canadian (Bi-National) Standard for Safety of
Information Technology Equipment, Including Electrical Business Equipment, CAN/CSA C22.2,
No. 950-95 * UL 1950, Third Edition, including revisions through revision date March 1, 1998, which
are based on the Fourth Amendment to IEC 950, Second Edition. In addition, this product was also
evaluated to the applicable requirements in UL 1950, Annex NAE.
WARNING - This unit is intended for installation in a Restricted Access location in accordance with
Articles 110-18, 110- 26, and 110-27 of the United States National Electric Code ANSI/NFPA 70.
This equipment should be installed in accordance with Article 810 of the United States National
Electrical Code.
When installed, this equipment is intended to be connected to a Lightning/Surge Protection Device
that meets all applicable national Safety requirements. TO AVOID INJURY, RISK OF FIRE, AND
DAMAGE, DO NOT CONNECT THIS PRODUCT DIRECTLY TO AN ANTENNA, AND ENSURE
THAT PROPER LIGHTNING ISOLATION IS ALSO PROVIDED BETWEEN THIS UNIT AND OTHER
EQUIPMENT.
Equipment is to be used and powered by the type of power source indicated on the marking label
only.
This product is intended to be connected to a + 24 VDC OR + 48 VDC power source which must be
electrically isolated from any ac sources and reliably earthed. Only a DC power source that
complies with the Safety Extra Low Voltage (SELV) requirements in the Standard for the Safety of
Information Technology Equipment, Including Electrical Business Equipment, CAN/CSA C22.2,
No. 950-95 * UL 1950, Third Edition, can be used with this product. A 15-Amp circuit breaker is
To Next Page
Loading...