Westfield XTR2 - Page 100

16.4
Step 3: Fuel Filter Installation
Position Bracket As Shown, Mark Hole Centres, Drill Through Floor Plate Using 3.2mm Drill Bit &
Rivet Bracket To Floor. Secure Filter With Jubilee Clip.
View From Inside Engine Bay
Step 4: Secondary Fuel Pump Installation -`Facet’ Type Pump
Fit Aluminium Bracket To Chassis then Secure the Pump to the Bracket.
View From Inside Engine Bay
Earth Lead (Orange)
Secure Under Fixing Nut
Power Lead (Black)
Green Wire On Main Loom
Fuel Tank
Jubilee Clip
Fuel Filter
Fuel Filter Bracket
Front
Of Car
`Facet’ Fuel Pump
A
luminium Chassis Bracket
Rubber Mountings
NOTE
The Rubber Mountings MUST Be
Fitted Between The Pump Bracket
A
nd The Aluminium Bracket
Power Lead (Black)
Earth Lead (Orange)
Secure Under Fixing Nut
Front
Of Car
Front
Of Car
`Facet’ Fuel Pump
Screw Connectors Into Pump
Housing. Use PTFE Tape On
Threads To Seal.
View From Passenger Side Of Car