28
Trainer can assist students in learning flight skills
and improving flight levels based on their flight
experience and operational level. A special trainer
line (sold separately) is required between the trainer
and the trainer to connect. The trainer must open the
trainer mode before the trainer can operate. When
the trainer switch is turned off, it will return to the
trainer transmitter to control the flight. When the
student machine flight is dangerous or the deviation
is too large, you can switch immediately to ensure
safety.
Note:
Be sure to confirm all the channels of the trainer
and the student before flying.
Can be controlled normally. Be sure to confirm
that the interface of the trainer line is firmly inserted.
Free from looseness. The trainer switch is set to
switch SD by default.
Types:
Normal, trainer: as the control transmitter;
Simulator: When practicing flight through the
computer-side simulator, the RF is turned off,
reducing power consumption to extend the
transmitter working time;
Student: Turn off the RF transmission right, only
the trainer can open the trainer switch to control the
turn on channel of the trainer! (Example: The trainer
has only three channels of aileron, direction, and
gyroscope open, then the student can only control
these three channels if the trainer plays the trainer
switch.)
Mode:
The default is "8 channel" setting, compatible with
the world's "WFT" series
Product trainer function. The trainer's two ET07s
need to set the same mode.
When WFT08/09 is used as the trainer, please
purchase the special analog cable for WFLY and
the 3.5mm male to male cable.
Steps:
1 WFT08/09, press and hold the MENU key to turn
on → modulation type, set to PPM mode.
Connect the servo to the receiver and connect the
servo. Connect the trainer line to boot
2 Settings: ET07 enters the [Trainer/Simulator]
menu, the mode is set to "Student", the channel is
set to "8 channels", and after a few seconds, the
mode detection and switching can be completed.
3 Verification: WFT08/09 toggles the coach
switch to position 2 and operates the ET07 related
stick or other switch. Check if the servo of the
corresponding channel is working normally.
Enter the interface: → System Setting→ WFLY
Trailer / Simulator
Trainer port
Trainer/Simulator
STU
00: 1 2: 02
Trainer
Type
Student
8CH
Mode
Setting method:
Press the key - dial arrow key to select the item;
press the Enter key/Add/Down key to switch the
working mode, switch, and controlled channel
switch. The return key exits the interface and saves.
Touch Screen - Click the "Type" key to switch the
working mode (Trainer mode: click the
corresponding key to toggle the switch or turn the
controlled channel on/off). Click the function name
in the upper left corner to exit the interface and
save.
System Setting
To Next Page
Loading...
