44
Through the 9-point curve, the throttle output
curve is adjusted for the action of the throttle stick to
achieve the optimal flight state of the engine
(motor).
* Each fly mode can set the curve.
The control switch needs to be set in [Model
Menu] → [Fly Mode].
The curve control switch for throttle hold needs
to be set in [Model Menu] → [Throttle Hold].
Note: When starting the engine, be sure to start
the engine at normal idle down in normal mode.
Enter the interface: → Model Menu→ WFLY
Throttle Curve.
Setting method:
Press the - arrow keys to select the setting item,
and press the plus or minus key to adjust the value.
The Back button exits the interface and saves the
settings.
Touch Screen - Click to select the setting item and
click the value, click the setting button on the right to
edit the value. Click on the function name in the
upper left corner to exit the interface and save the
settings.
Throttle Curve(Airplane)
Make Channel 6 as trim step function.
Note:The “Flap Trim” function uses the “V1
knob” for operation control, which can adjust the
travel of the trim lever. “V1 knob” can customize
the switch or knob in [Aux Channel].
Enter the interface: → Model Menu→ WFLY
Flap Trim
Setting method:
Press the - arrow key to select the setting item,
and press the plus or minus key to adjust the
value. Click the Back button to exit the interface
and save the settings.
Touch screen - click to select the setting item
switching option, (click the value)
Click the Settings button on the right to edit the
parameters. Click on the function name in the
upper left corner to exit the interface and save
the settings.
V1 Netrual
V1 Rotary
Flap Trim(Airplane)
To Next Page
Loading...
