50
When the swash type is selected as HR3 (120°),
HE3, HN3 (120°), H-3, this function can be used to
adjust the end point. The ailerons, elevators, end
point and directions of the pitch can be adjusted.
Note:
If the end point is set too large, the structure of the
connection may be damaged during the compound
operation. Due to the wrong direction of the
helicopter connection, etc., even if the servo is
connected in accordance with the position specified
in each of the above swash types, the swash rate
may not operate correctly. Please adjust the
operation of each servo described in the helicopter
instruction manual with [Servo Reverse]. In
addition, if the aileron, elevator, and pitch are
reverse-adjusted, pay attention to the change of the
rate polarity in the AFR function of the swash.
Interface Path: →Model Menu→SwashWFLY
Setting method:
Press the - arrow keys to select the setting item,
and press the plus or minus key to adjust the value.
Click the Back button to exit the interface and save
the settings.
Touch Screen - Click to select the setting item to
switch options,(click the value)click the right set key
to edit the parameters. Click on the function name in
the upper left corner to exit the interface and save
the settings.
RX
HR3(120°)
50%
50%
50%
00: 1 6: 06
Type
Pitch
Aileron
Elevator
Swash
Pitch
Aileron
Elevator
Adjust Servo
Switching swash types
Swash (Helicopter)
The initial setting switch of the fly mode switch
(Normal, Idle 1, Idle 2) is SC. Before setting other
functions, please set the fly mode function firstly.
Note:
● After the function is activated, when the function
control switch is set to the third position, the initial
setting switch and mode are: normal (gear position),
Idle 1 (position), Idle 2 (under gear).
● When the function control switch is set to two
position, the functions are only: normal (on gear)
and Idle 2 (under gear).
Enter the interface: → Model Menu → Fly WFLY
Mode .
Setting method:
Press the - arrow keys to select the setting item,
and press the plus or minus key to adjust the value.
Click the Back button to exit the interface and save
the settings.
Touch Screen - Click to select the setting item to
switch options. Click on the function name in the
upper left corner to exit the interface and save the
settings.
Fly Mode(Helicopter)
Fly Mode
INH
Fly Mode
Normal
00: 0 6: 59
Normal: Used when hovering.
Idle 1: Air route, somersault and snap roll
Idle 2: 3D, fly back
Locking: Throttle lock mode, the function of
switching off the fly mode is as follows:
When using the following functions, you need to
preset the fly mode control switch and set the curves
or parameters of different flight modes according to
the actual use of the model.
[Throttle Curve], [Pitch Curve],
[Gyro], [Governor]
Model Menu
To Next Page
Loading...
