43
Assign the channel output position of the aileron-
2. The aileron 2 and the aileron are mixed to form a
flap, and the aileron 2 is required if the flap function
is required. The aileron 2 can be provided as a
channel 5 or a channel 7.
Enter the interface: → Model Menu → WFLY
Aileron 2
Setting method:
Press the button--press the plus or minus button
to adjust the value. Click the Back button to exit the
interface and save the settings.
Touch Screen - Click to select the setting item to
switch options.Click Function name(the top left
corner) to exit interface and save settings.
Aileron 2(Airplane)
The initial setting switch of the flight mode switch
(Normal, Idle 1, Idle 2) is SC. Before setting other
functions, please set the fly mode function firstly.
Note:●After the function is started, when the
function control switch is set to the third position,
the initial setting switch and the square are: normal
(Gear Up), Idle 1 (Gear Middle), and Idle 2 (Gear
Down).● When the function control switch is set to
two positions, the functions are only: normal ( Gear
Up) and Idle 2 (Gear Down).
Enter the interface: → Model Menu → Fly WFLY
Mode
Fly Mode(Airplane)
It is easy to use the throttle cut function to turn off
the engine. It is only necessary to toggle a switch in
the idle state to achieve engine stall or motor stop.
After the throttle cut function is enabled, the throttle
cut or the ESC's fully flameout position can be
adjusted. After the function is activated, regardless
of the throttle lever position, the throttle output
remains at the set position. The cut function does
not start in the high speed throttle state, avoiding
erroneous operation. For safety reasons, it is
recommended to set the throttle cut function.
Note: After the throttle cut function is enabled,
the function is turned off again. The throttle action
determines that the sticker has no power output
when it is in the high position. Only when the oil level
(servo position) is increased from the low position of
the throttle, the normal throttle output can be
restored!
Interface path: → Model Menu → AIL WFLY
Differential
Setting method:
Press the key - Press arrow keys to select the
setting item, and press the plus or minus key to
adjust the value. Click the Back button to exit the
interface and save the settings.
Touch Screen - Click to select the setting item
switching option, (click the value) and click the
setting button on the right to edit the parameter.
Click on the function name in the upper left corner to
exit the interface and save the settings.
The throttle position
where the function is
released (the value on
the right indicates the
current throttle stick
position.)
Adjust the throttle cut
position (here adjust
the throttle servo or the
rate of the position
where the ESC is
completely cut.)
CH6&5
Aileron 2
AIL 2
00: 0 6: 59
Normal: Fly mode 1, corresponding to the throttle
curve of the normal mode.
Idle 1: Fly mode 2, corresponding to the throttle
curve of the effect 1 mode.
Idle 2: Fly mode 3, corresponding to the throttle
curve of the effect 2 mode.
The functions that need to be switched by fly
mode are as follows:
When using the following functions, you need to
preset the fly mode control switch and set the curves
or parameters of different fly modes according to the
actual use of the model.
[Throttle Curve] [Multicopter] [Throttle Curve]
Model Menu
To Next Page
Loading...
