34
The range check is mainly used to test the
distance.
Note: Turn on the telemetry when linking. After
linked, the transmitter receiver can be connected
normally to use this function! Only enter this
interface, after toggling the SH switch, the power
will be reduced! The control distance is related to
the actual use environment!
Interface path:
WFLY → Linkage Setting → Range Check
90.00°
90°
Open Area
1
Transmitter antenna
Vertical to the ground
90° direction
2
Test from 1.5m height
approximately distance
from the ground
3
Transmitter antenna
90° to each other
(vertical) layout!
*[range Check]The results are for reference only and are not intended as the only performance
standard, depending on the specific usage environment!
Range Check
Instructions:
1. Enter the interface and toggle the SD switch.
2. The transmitter and receiver maintain a certain
height (about 1.5 meters) and the antennas are in
the same direction (perpendicular to the ground).
3. The transmitter and receiver are powered, start
moving position, move the stick,
4, The transmitter to view the signal strength of
the "RX" in the upper right corner of the screen
(The receiver receives the strength of the
transmitter signal) and the receiver checks to see if
the status light and servo are moving smoothly. This
comprehensive evaluation of the working distance!
Signal strength judgment:
The transmitter signal strength returned by the
receiver can be viewed in the upper right corner of
the screen status bar (the standby interface during
normal operation) and the signal strength
percentage indication ([Range Test] function
interface). The more indicator bars, the larger the
percentage value. The better the signal, conversely,
the worse signal. The status bar has no signal bar
indication, and there is no signal when the signal
strength is 0%.
To Next Page
Loading...
