45
This function is used for the mixing of the elevator
to the flap action. Generally, it is set to mix the
elevator up and the flaps down. A model airplane for
fun flying, for small-scale squashing.
Note:The rate of the upper/lower sides can be
adjusted individually.
Enter the interface: → Model Menu → WFLY
ELE to Flap
Setting method:
Press the - arrow keys to select the setting item,
and press the plus or minus key to adjust the
value.Click the Back button to exit the interface and
save the settings
Touch screen - click to select the setting item
switching option (click the value).Click the Settings
button on the right to edit the parameters. Click on
the function name in the upper left corner to exit the
interface and save the settings.
The two ailerons are used in the ailerons, so that
the ailerons can also have the mixing function of the
flaps. As the ailerons act, the ailerons are lifted at
the same time. When this mixing and air brake are
used together, the speed can be reduced when
landing, and it is effective when flying in a narrow
place.
Connect the right aileron servo to CH1 (aileron)
and the left aileron servo to CH6 (flaps).
Notice:The upper and lower rudder angles of the
left and right aileron rudder surfaces can be
adjusted separately.
The amount of left and right flap motion can be
adjusted separately.
The flap aileron mixing control, the aileron
differential, and the lifting aileron mixing control
cannot be started at the same time. When other
mixing controls have been enabled, the pop-up
window will display conflicts on the interface.
Please set other mixed mixing controls to be
disabled first. Then set the flap aileron mixing to
enabled.
Enter the interface: → Model Menu→ WFLY
Flaperon
Setting method:
Press the - arrow keys to select the setting item,
and press the plus or minus key to adjust the value.
Click the Back button to exit the interface and save
the settings.
Touch Screen-Click to select the setting item
switching option, (click the value) and click the
setting button on the right to edit the parameter.
Click on the function name in the upper left corner to
exit the interface and save the settings.
To Next Page
Loading...
