Wfly ET07 - S.BUS Servo; Ppm;W.bus; Rx Port Setting

36
The S.BUS servo can memorize its own channel
and different settings. the servo channel could be
set through connecting servo on Et07.
Notice:
1Before using this function, you need to enable
the [Telemetry] function and the receiver is
connected normally.
2 When setting, only one BUS servo can be
connected for setting at a time.
3 When using the S.BUS servo, ensure that the
power supply is sufficient, otherwise the servo will
have an abnormal situation such as unstable output!
Interface path:
WFLY → Linkage Setting→ W.BUS Servo
Setting method: The use of W.BUS function is
mainly to allocate channel parameters for BUS
servo, which is divided into three main steps.
Prerequisite: The transmitter and receiver are
linked (turn on telemetry) and linkage normally.
First, read the S.BUS servo ID.
Connect the S.BUS servo to the "W.BUS2 slot" of
the receiver and the transmitter clicks the "Read"
button.
Second, the channel allocation.
In the "Function" setting item, select the
corresponding channel according to the function of
the servo. Click the "Write" button, set the servo
channel and complete the parameter saving, and
exit the setting interface.
Third, verify the servo channel.
Turn on the monitor, connect the servo to the
"PPM/W.BUS" interface, and operate the stick or
switch knob (currently connected to the channel set
by the servo).
Switching the output mode of receiver
PPM/W,BUS(the 8th slot)
Notice: PPM mode(RF207S). The 8th slot outputs
a standard 2048 resolution, 8 channel PPM signal.
Interface path:
WFLY → Linkage Setting→ PPM/W.BUS
Setting method:
Press the button - press the plus or minus button
or the confirm button to switch the mode. The Back
button exits the interface and saves the settings.
Touch screen - click the button to switch modes.
Click on the function name in the upper left corner to
exit the interface and save the settings.
S.BUS Servo
PPM/W.BUS
RX
NOR M
4.2 V
Write
Servo
ID
010
Channel
Read
65535
1
W.BUS Servo
00: 0 6: 59
RX
NOR M
4.2 V
PPM / W .B US
PPM/W .B US
W.BUS
00: 0 6: 59
Linkage Setting
W.BUS2
Port
1 read the S.BUS servo ID
W.BUS2
PPM/W.BUS
2 channel allocation
3 verify the servo channel
Port
Port
Receiver port setting function could applied to
receiver ports flexibly
Interface path:
WFLY → Linkage Setting→ Rx port setting
*W.BUS2 could only be set to the receiver
port where marked "W.BUS2" .(Different
receivers could be set as different
parameters, please refer to the receiver lable
mark.)
Rx port setting
RX
NOR M
4.2 V
Rx port setting
00: 0 6: 59
1
6
2
7
3
8
9
4
5
Port Port
Channel Channel
W.BUS
W.BUS 2
Reset
7
6
4
5
3
2
1