Wfly ET07 - Ailvator (Airplane); V-Tail (Airplane)

48
This function makes the elevator gets the function
of an aileron, and the performance of the aircraft
snap roll is improved. The aileron elevator is to
make the two rudder surfaces on the normal layout
or the V-Tail like the ailerons, moving upwards and
the other side. The lower movement, on the V-tail, is
called the directional elevator, because they are the
same on the left and right. In a typical application,
the aileron elevator is linked with the aileron,
especially on the aircraft of the large wingspan.
Maximize the snap roll effect.
Notice:
The amount of motion of the ailerons and
elevators can be adjusted separately. Depending on
the connection, the direction of motion will be
different, so check the direction of the operation
carefully.
Ailvator, V -Tail, Elevon, can only be activated
one at a time! Open the second one will have a pop-
up warning!.
CH2
AIL Moving
AIL3
ELE Moving
ELE 1
AIL3(CH2)
Interface Path: →Model Menu→AilvatorWFLY
Setting method:
Press the - arrow keys to select the setting item,
and press the plus or minus key to adjust the value.
Click the Back button to exit the interface and save
the settings.
Touch Screen - Click to select the setting item
switching option, (click the value) and click the
setting button on the right to edit the parameter.
Click on the function name in the upper left corner to
exit the interface and save the settings.
Ailvator (Airplane)
This function makes the elevator get the function
of an aileron, and the performance of the aircraft roll
is improved. The aileron elevator is to make the two
rudder surfaces on the normal layout or the V-Tail
like the ailerons, moving upwards and the other
side. The lower movement, on the V-tail, is called
the directional elevator, because they are the same
on the left and right. In a typical application, the
aileron elevator is linked with the aileron, especially
on the aircraft of the large wingspan. Maximize the
effect.
Note: Ailvator, V-Tail, and Elevon,only one can be
activated! Opening the second one will have a pop-
up warning!
CH2(CH4)CH4(CH2)
CH2
CH4
ELE Moving
AIL1
ELE2
RUD Moving
ELE2
RUD1
Enter the interface: → Model Menu→ V-WFLY
Tail
Setting method:
Press the - arrow keys to select the setting item,
and press the plus or minus key to adjust the value.
Click the Back button to exit the interface and save
the settings.
Touch Screen-Click to select the setting item
switching option, (click the value) and click the
setting button on the right to edit the parameter.
Click on the function name in the upper left corner to
exit the interface and save the settings.
V-Tail (Airplane)
RX
NOR M
4.2 V
INH
Status
+50%
-50%
+50%
+50%
ELE1
ELE2
RUD2
RUD1
V-Tail
00: 0 6: 59
RX
NOR M
4.2 V
INH
Status
+100%
-50%
Aileron3
ELE1
Ailvator
00: 0 6: 59
Model Menu