4.1. Inspection Before Getting into the Device
Perform the following inspection before getting into the device.
¢
Inspection contents
1. Inspection with the power off
• Check that the power is turned off.
• Check that all parts are correctly assembled and that there are no missing or broken parts.
• Check that there is no damage, corrosion, or other problems.
• Check that the device exterior, arm, anti-tip bar, and other parts are not deformed, damaged, or
loose.
• Check that the connecting parts at release points are not deformed, damaged, or loose.
• Check that the controller knob moves smoothly.
• Check that there is no cracking or wear of the front omni-wheels.
• Check that there is no cracking or wear of the rear wheels.
• Check that the prural brakes can be released and the device can be pushed manually.
• Check that when the prural brakes are locked, the wheel chair does not move when pushed.
• Check that the anti-tip bar is lowered.
• Check that the release levers are locked.
2. Inspection with the power on
• Check the battery charge level indicator and check that the charge level is sufficient.
• Check that the switches on the control pad function.
• Check that the display function correctly.
• Check that the horn is functional.
If any problems which you cannot correct yourself are found during the above inspection, contact
your distributor or WHILL Customer Support.
To Next Page
Loading...
