5.2. Assembly Procedures
Assembly of the device does not require tools. When assembling the device, pay careful attention to the following.
WARNING
When assembling the front drive base and rear drive base, be sure to grasp the handle A.
There is a risk of injury if fingers are caught in the disassembly mechanism.
Perform assembly in a flat, level location.
There is a risk of unexpected accident.
CAUTION
When assembling the device, grasp only the handle parts that are explained in this manual,
and do not hold the device by any other areas.
There is a risk of injury caused when a hand become caught in the device.
When assembling, check that the magnetic connectors are not dirty.
If a magnetic connector is dirty, current may not flow through it, and the power may not turn
on. The magnetic connectors are located at the connection between the seat assembly and
rear drive base, and the connection between the battery and rear drive base.
5.2.1. Assembling the Front drive base and Rear drive base
To Next Page
Loading...
