Williams Electronics WHIRLWIND - Page 18

GAME ADJUSTMENT
PROCEDURE
(Continued)
3.
With
the
desired Game
Adjustment Item
number
showing in the lower display, increase the
setting
value
(or
select another
option)
shown in the lower
display
by using
AUTO-UP and
pressing
the
Credit button.
Repeat
this step
for
each
item,
until
all changes
to the factory
settings
for
the
Game
Adjustment Items
have been made.
The
preceding Game
Adjustment Table
consolidates
the Factory
Settings
into
one grouping.
(The
same
procedure
can
be
used
for
Audit
Items.
To
zero Au 01
-
04 (concerning
the coin
chutes and
the total coins),
the
operator
can
proceed
to
item
68, Clear
Coins, and
press the
Credit
button to
obtain
the YES
option.
The
operator then presses
the ADVANCE button
and
notes
the
"DONE"
display,
which verifies
that
the
entry
values for items 01
through 04 of
the
Audit
items
are
now reset
to
zero.)
For
example,
the operator
may
desire
to
change the degree
of game
play difficulty
from
the
Factory
Setting
(equivalent
to the
Install Medium
[Ad
64]
difficulty, along
with a number
of other
automatically
installed
settings,
as shown
in
the
right column
of
the Game Adjustment
Table) to
another
difficulty
more suitable
for the players
at a particular
game
site.
Four
other ‘automatic’
play
difficulty settings (Ad
62
-
Ad
66) are available,
each
of
which,
if selected,
installs all
the
adjustments
listed
for that
difficulty
in
the
Game Adjustment Setting
Comparison Table,
which
precedes
the
‘details’
text.
4.
To
proceed
rapidly
through
the
entire
adjustments
series,
press and
hold ADVANCE,
until Ad
70
shows
in
the lower display. From item
70,
you can:
(A) return to the
;
or (B)
restore
factory
settings and
zero
audit (bookkeeping) totals.
Perform
either
of the
following, as
deshed:
A.
To
reach
,
use
AUTO-UP and
press
ADVANCE
once. Wlhmrlxmlllmdl
now goes
to the .
B. To restore
the
Factory
Settings for
Game
Adjustment
Items
(as listed in the
Game Adjustments
Table),
zero
all
audit
(bookkeeping) totals,
and
return to
,
use
AUTO-UP or
MANUAL-DOWN
to
display Ad 70
in the
lower
display.
Press
the Credit
button to display
the
YES
option
in
the
lower
display.
Using AUTO-UP,
press
ADVANCE
once.
Wlhllirlltwlimcetl
now
zeroes ALL Audit
ltem totals and changes
ALL
Game
Adjustment
Items
back to
those originally
selected
as Factory
Settings. it
then
shows
the operator
a message
("FACTORY
SETTING")
that
this
has
occurred.
(A problem
in
the
Memory
Protection
circuit or
closing the
coin door
will
cause the
message "ADJUST FAILURE"
to
appear.)
Press
ADVANCE
once more to
return to
the .
Whllirllwlluncril
fl
4}