WinGD X35-B - Page 6

8.1 Prepare the engine before start - general....................................286
8.2 Prepare the engine before start............................................288
8.3 Start the engine - general.................................................296
8.4 Start the engine..........................................................298
8.5 Do checks during operation - general.......................................300
8.6 Do checks during operation............................................... 302
8.7 Do regular safety checks..................................................306
8.8 Maneuver the ship - general...............................................310
8.9 Maneuver the ship.......................................................312
8.10 Change-over the diesel fuel - general.......................................314
8.11 Change-over the diesel fuel automatically...................................318
8.12 Change-over from HFO to MDO manually...................................320
8.13 Change-over from MDO to HFO manually...................................322
8.14 Stop the engine - general.................................................324
8.15 Stop the engine..........................................................326
8.16 Emergency stop the engine - general.......................................328
8.17 Emergency stop the engine............................................... 330
8.18 Prepare the engine after stop - general..................................... 332
8.19 Prepare the engine for a short service break.................................334
8.20 Prepare the engine for a long shutdown period...............................336
9 Service during operation
9.1 Do an analysis of the system oil............................................342
9.2 Do an analysis of the cylinder oil...........................................344
9.3 Replace the filter element of the duplex filter.................................348
9.4 Clean the turbocharger during operation....................................350
9.5 Clean the scavenge air cooler during operation..............................352
9.6 Do a test of the exhaust waste valve........................................356
9.7 Running-in of new components - general....................................358
9.8 Running-in of new components............................................360
10 Troubleshooting
10.1 Troubleshooting - general data............................................ 364
10.2 Malfunctions of systems and components...................................366
10.3 Failures and defects of UNIC-flex components...............................386
10.4 Examine the supply unit for servo oil leakage................................388
10.5 Examine the supply unit for fuel leakage....................................392
10.6 Examine the rail unit for leakage...........................................396
10.7 Examine the FLV or fuel pipes for fuel leakage...............................398
10.8 Temporary cut out a defective injection valve................................ 402
10.9 Temporary cut out a defective exhaust valve drive............................404
10.10 Temporary isolate a cylinder with cooling water leakage.......................406
10.11 Temporary isolate a defective turbocharger..................................410
X35-B
Operation Manual
Winterthur Gas & Diesel Ltd.
- 6 - Issue 001 2019-10