To Next PageTo Next Page
Need help?Do you have a question about the Wlan BOX WB100A and is the answer not in the manual?
General| Wireless Standards | IEEE 802.11b/g/n |
|---|---|
| Frequency Band | 2.4 GHz |
| Maximum Data Rate | Up to 150 Mbps |
| Ports | 4 x 10/100 Mbps LAN, 1 x 10/100 Mbps WAN |
| Antenna | 2 x External Antennas |
| Security | WEP, WPA, WPA2 |
| Dimensions | 140 x 90 x 30 mm |
Explains how to access and log in to the WB100A's web-based configuration interface.
Explains WAN connection settings, specifically the static IP configuration.
Explains DHCP mode for internet connection configuration.
Explains PPPoE mode for WAN connection, including account and password setup.
Describes Bridge Mode for WAN connection, where the LAN port uses PPPoE to connect to the internet.
Details the configuration of the Local Area Network (LAN) settings, including IP address and DHCP server.
Configures basic wireless network settings like SSID, network mode, and radio status.
Sets up security modes like WPA2-PSK, WPA-PSK, and OPENWEP for wireless network encryption.
Configures the basic settings for the first SIP line, including proxy and registration details.
Details audio configuration options for SIP calls, including codec types and packet settings.
Configures supplementary services like Call Waiting, MWI, DND, and Speed Dial for the SIP line.
Sets up SIP parameters, including SIP T1, Max Forward, and NAT Traversal settings for VoIP.
Covers advanced SIP settings like domain name type, signal port, RTP port, and SIP message handling.
Configures SIP parameters such as SIP T1, Max Auth, SRTP, and NAT Traversal settings.
Manages device settings, including configuration file upload/download and administrator account details.
Configures NTP settings for time synchronization and setting the device's time zone.
Provides instructions for upgrading the WB100A's firmware to the latest version.
Provides instructions for upgrading the device firmware from a local file.
