123
This setting then appears as a symbol in the display:
switch on
switch off
cleaning + off
Press the OK soft key to confirm your selection.
A programmed switching time can be cleared again by
pressing the C soft key (deletion visible in the indicator
--‘--).
If you use the Plus (up arrow) and Minus (down arrow)
keys in the “Action” column, after scrolling through the
setting options in Operating Time mode, you will
automatically move on to the setting options in other
modes, such as Cleaning mode (see chapter 10.1.3 on
page126), Preselection, (see chapter 10.1.2 on page 124) or
Self-service mode (see chapter 10.1.4 on page 127).
The column heading “Prg” denotes the 16 switching times
that can be set for each day. Once you have pressed the OK
soft key to confirm the desired action, all the programmed
switching times will automatically be arranged in
chronological order.
By pressing the
soft key in the display as a check, you
can access the Timer Check directly (see chapter 10.2
Timer check on page 129).
To Next Page
Loading...
Need help?
General
