129
If you use the Plus (up arrow) and Minus (down arrow)
keys in the “Action” column, after scrolling through the
setting options in Self-service mode, you will automatically
move on to the setting options in other modes, such as
Preselection mode (see chapter 10.1.2 on page 124),
Operating Time (see chapter 10.1.1 on page 121) or
Cleaning mode (see chapter 10.1.3 on page 126).
The column heading “Prg” denotes the 16 switching times
that can be set for each day. Once you have pressed the OK
soft key to confirm the desired action, all the programmed
switching times will automatically be sorted in
chronological order.
By pressing the
soft key in the display as a check, you
can access the Timer Check directly (see chapter 10.2
Timer check on page 129).
10.2 Timer check
To check your programmed switching times in the Timer
Check, press the
soft key in the selection menu.
The following display appears:
Then press the TimerTable soft key.
You can now display the preset operating times or your
programmed preselection settings in the timer check.
To Next Page
Loading...
Need help?
General
