wolke M600 - How to Adjust Print Resolution; How to Change Product Direction; How to Change Product Orientation

Rev AB How to Setup the Printhead Settings 5-17
Wolke m600 touch Operator Manual
Note: The printhead cannot be purged, if external sensor is configured and
the product is positioned in front of the sensor.
4 Navigate to Tools > Setup >Consumables > Purge. The Purge Printhead
screen appears.
How to Adjust Print Resolution
5 Navigate to Tools > Setup > Printhead > Horizontal Print Density. Select
the appropriate print density value and touch OK to confirm.
6 Navigate to Tools > Setup > Printhead > Vertical Print Density. Select the
appropriate print density value and touch OK to confirm.
How to Change Product Direction
7 Navigate to Tools > Setup > Printhead > Product Direction. Select the
appropriate direction and touch OK to confirm.
How to Change Product Orientation
8 Navigate to Tools > Setup > Printhead > Product Orientation. Select the
appropriate orientation and touch OK to confirm.
Figure 5-23: Print Resolution