Safety
PROPER PROCEDURE FOR CONDUCTING ELECTRICAL SAFETY CHECKS AND
2
2-7 15doc092319 Safety
WARNING! Release pressure from the up/down assist prior to performing any
service to the assembly (Rev. E4.00+). Failure to follow this may result in the
assembly flying apart, causing injury or damage to the equipment.
WARNING! The gas spring cylinders are pressurized (Rev. E4.00+). Disas-
sembly of cylinder may result in injury or damage to the cylinder.
GENERAL TRAILER SAFETY
DANGER! Make sure your hitch has adequate safety chain hookups. Do not
use eyebolts for safety chain hook-up. Safety chains should be hooked to
bumper of vehicle so that each chain would pull the trailer equally in the event
the hitch became disengaged. Failure to follow this may result in serious per-
sonal injury and/or severe machine damage.
DANGER! Be sure that the hitch and safety chains are secure before towing
the sawmill. Failure to follow this may result in serious personal injury and/or
severe machine damage.
DANGER! Make sure all light connections have been made and are working
properly before towing the sawmill. Failure to follow this may result in serious
personal injury and/or severe machine damage.
WARNING! The trailer option is designed for the express purpose of towing
the sawmill it is supplied with. Do not make modifications or additions that
affect the weight and/or stability of the towing unit. Doing so may result in
property damage and/or serious injury or death.
WARNING! Always check trailer tires for proper inflation before towing saw-
mill. Failure to follow this may lead to tire failure resulting in property damage
and/or serious injury or death.
2.3 PROPER PROCEDURE FOR CONDUCTING ELECTRICAL SAFETY
CHECKS AND MAINTENANCE
DANGER! Make sure all electrical installation, service and/or maintenance
work is performed by a qualified electrician and is in accordance with applica-
ble electrical codes.
DANGER! ARC FLASH AND SHOCK HAZARD! Hazard-
ous voltage inside the electric sawmill disconnect box,
starter box, and at the motor can cause shock, burns, or
death. Disconnect and lock out power supply before servic-
ing! Keep all electrical component covers closed and
securely fastened during mill operation. Wear appropriate
Personal Protection Equipment.
WARNING! Consider all electrical circuits energized and dangerous.
To Next Page
Loading...
