To Next Page

To Previous Page

Remote Operation

Preparing for Remote Operation

1-5 ROdoc070822 Remote Operation

1.3 Preparing for Remote Operation

Set up the sawmill as instructed in your sawmill operator’s manual.

CAUTION! Moving the saw carriage before removing the

cable chain support may cause damage to the chain. Also,

moving the saw carriage when the chain is frozen can

damage the chain. See Section 1.6

for recommended chain

deicing procedure.

See Figure 1-4. Before moving the saw carriage, remove the cable chain support

bracket.

1. Disengage the rubber strap holding the cable chain to the support bracket.

2. Loosen the handles and remove the support bracket from the sawmill track rail.

3. Place the support bracket on the storage bracket located on the sawmill frame between

the first and second bed rails. Tighten the handles to secure the support bracket to the

storage bracket and secure the rubber strap in the bracket hole.

FIG. 1-4

Store chain support on

bracket between first

and second bed rails

3H0479

Remove strap

from cable chain

Loosen handles

and remove

chain support