Sawmill Assembly
Tools required
Sawmill Assembly WMdoc041521 3-1
3
SECTION 3 SAWMILL ASSEMBLY
IMPORTANT! Do not unbolt all the shipping brackets at once. Remove
the shipping brackets securing the sawmill to the pallet at each step to
prevent inadvertent shifting of the parts.
3.1 Tools required
Lifting device (fork lift, crane, etc.)
Socket set, metric and imperial
Open-end wrench set, metric and imperial
Socket driver
Utility knife
Rubber mallet
Two blocks, minimum 5-1/2” tall. (Ideal size: 5-1/2 x 5-1/2 x 20”)
CAREFUL PLANNING IS ESSENTIAL TO A SMOOTH ASSEMBLY.
READ THIS SECTION THOROUGHLY TO PLAN THE ASSEMBLY.
To Next Page
Loading...
