Wood-mizer LX150 - Uncrating the Sawmill

Sawmill Assembly
Uncrating the mill
3
3-2 WMdoc041521 Sawmill Assembly
3.2 Uncrating the mill
See Figure 3-1.
1. Remove any shipping straps or plastic coverings from the mill before beginning.
2. Remove and inspect the parts boxes. (See Table 1.)
NOTE: If the saw head blocks the parts boxes, the head can be raised
using the operator’s control. The battery is connected at the factory, so
power is available to raise the head. See
See Section 5.2 Up/Down
Operation.
3. Leave the blade in its box.
FIG. 3-1