Sawmill Assembly
Leveling the bed
3
3-12 WMdoc041521 Sawmill Assembly
1. Remove the F81003-50 M10x80mm mounting bolts for the log support/clamp one bed
section.
2. Remount the log support/clamp and the travel lock with the longer F05022-22
M10x90mm and the F05004-270 M10 nylock nuts.
See Figure 3-11.
Leveling the bed
NOTE: Leveling the bed is best done before setting the saw head on
the log bed.
1. Adjust the frame legs so the sawmill appears level as shown in Figure 3-7and 3-8.
2. Run a string from the front bed rail to the rear bed rail near the operator’s side of the
frame. See Figure
3-12.
3. Place IDENTICAL matching spacers between the string and the front and rear bed rails.
4. Measure the distance between the string and the other bed rails.
5. Adjust the frame legs until all bed rails measure the same distance from the string.
FIG. 3-11
F05022-22, M10x90mm
F05004-270 M10 nylock nuts
To Next Page
Loading...
