Wood-mizer LX150 - Blade Guide Arm Operation

Sawmill Operation
Blade Guide Arm Operation
5
5-6 WMdoc120220 Sawmill Operation
See Figure 5-4.
5.4 Blade Guide Arm Operation
1. Set the outer blade guide to clear the widest section of the log by less than 1" (25.4 mm).
2. Use the blade guide toggle switch on the control panel to adjust the outer blade guide as
necessary.
3. Push the switch to the left to move the arm in; push the switch to the right to move the
arm out.
FIG. 5-4
LX1503-05
Leveling wedge
Raise log until the
heart is parallel with
the log bed