Sawmill Operation
Up/Down Operation
Sawmill Operation WMdoc120220 5-3
5
DANGER! Stay clear of the area between the trailer axle and saw car-
riage. Failure to follow this will result in death or serious injury.
5.2 Up/Down Operation
CAUTION! Ensure the blade is properly installed and tensioned
before moving the sawhead.
1. Use the up/down drum switch located on the right side of the control panel to raise or
lower the cutting head.
2. Hold the switch in position until the cutting head reaches the desired height, then release.
See Figure 5-2.
CAUTION! Ensure the up/down drum switch moves to the neutral
(off) position when released to ensure that the saw head stops
moving. If the switch remains engaged, manually move the switch
to the neutral or "off" position, then troubleshoot the switch.
CAUTION! DO NOT try to force the carriage above the 35" (88 cm)
mark or below the 1" (2.54 cm) mark. Damage to the up/down system
may result.
FIG. 5-2
To Next Page
Loading...
