Sawmill Assembly
Bumper Assemblies
3
3-10 WMdoc041521 Sawmill Assembly
See Figure 3-7.
9. Loosen the upper nut on the feet, then use lower nut to adjust the sawmill bed height;
retighten the upper nut.
See Figure 3-8.
10. Repeat this procedure for the third and fourth bed section.
3.3 Bumper Assemblies
IMPORTANT! The bumpers are left/right oriented, with the larger bum-
pers belonging on the same side as the log supports.
FIG. 3-7
FIG. 3-8
Set height
Tighten
To Next Page
Loading...
