Sawmill Assembly
Install Travel Locks
Sawmill Assembly WMdoc041521 3-11
3
See Figure 3-9.
1. Mount the bumpers to the frame with the shims between the frame and the bumpers.
See Figure 3-10.
Install Travel Locks
CAUTION! Do not attempt to move a fully assembled mill. Equipment
damage will occur.
If relocation of the mill is necessary, the saw head and mast may be
locked to ONE bed section for transport.
FIG. 3-9
FIG. 3-10
Large bumper
Large bumper
Log support
F81037-1, M20-8 nut
F81037-1, M20-8 nut
F81055-1, M10.5 flat
515061-1, Shim
To Next Page
Loading...
