Manual 37364A GCP-30 Packages - Genset Control
DPC - Direct Configuration Interface
NOTE
To configure via the configuration interface (direct configuration), you need the configuration cable
(part number 5417-557), the program LeoPC1 (delivered with the cable), and the corresponding confi-
guration files. Please consult the online help installed when the program is installed for a description
of the LeoPC1 program and its setup.
If the parameter "Direct para." is enabled on the control, communication via the CAN bus interface on
terminals X1/X5 is disabled.
If the control unit detects that the engine is running (ignition speed exceeded), the direct configuration
port is disabled.
© Woodward Page 41/46
To Next Page
Loading...
