Audemat Control Silver v.2.1.x User Manual – 06/2015
Page 27
Head Office : Parc d’activites Kennedy - 20, avenue Neil Armstrong – 33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 – contact@worldcastsystems.com – www.worldcastsystems.com
4.6. PPP Dialout
! Enabling PPP connections will suspend Phone Alert and Voice/DTMF functions!
When configuring from ScriptEasy, enabling one function will disable the other function’s tab. After disabling a
function, you’ll need to close the system configuration pages and open them again to enable the tab you need.
! Ethernet back up and PPP Dialout are mutually exclusive.
Configure outgoing calls from this page.
To configure outgoing calls: activation of outgoing calls
PPP as Ethernet backup:
This function makes it possible for the unit to switch to the PPP interface to send alarms if the
primary Ethernet interface (eth0) doesn’t function anymore (i.e. if a reference address doesn’t
answer to a ping).
This verification is done regularly and can be changed by the user. It may happen that the network
cable is unplugged or damaged, or that the equipment associated with the reference IP address is off
or not on the network.
To Next Page