Audemat Control Silver v.2.1.x User Manual – 06/2015
Page 36
Head Office : Parc d’activites Kennedy - 20, avenue Neil Armstrong – 33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 – contact@worldcastsystems.com – www.worldcastsystems.com
Automatic acknowledgement for sending with INFORM. These notifications are only available with the
version 2c of the protocol. This protocol checks that the manager sends the notification to the
transmitter. This process is simple and reliable, no specific configuration is required for the manager.
Manual acknowledgement for Traps V1 and Traps V2c. A specific OID (“alarmPendingAlarmsalarmAck”)
is extracted and its variables are sent with the trap. The manager must then execute a SET
command. This method is more complex but is the only one that can work with the version 1 of the
protocol.
The acknowledgment mode (Trap V1, Trap V2c or Inform) is identical for all alarms. See the next section
“Notifications” for additional settings.
With “SNMPv2c traps” notifications, it not possible to acknowledge traps.
In the same way, traps which do not require acknowledgment cannot be sent with the “Inform SNMPv2c”
format, even when this format is selected. This is the case with the ‘test’ trap as well as with equipment
information traps such as the ‘Equipment On’ trap.
4.13. Trap receiver
Set the SNMP community and the port to allow ScriptEasy to receive traps.
To Next Page
Loading...