Worldcast Systems AUDEMAT CONTROL SILVER - Notifications

Audemat Control Silver v.2.1.x User Manual – 06/2015
Page 37
Head Office : Parc d’activites Kennedy - 20, avenue Neil Armstrong – 33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 – contact@worldcastsystems.com – www.worldcastsystems.com
4.14. Notifications
SNMP Actions
The user may replay traps that have not been acknowledged yet.
The user may also delete pending traps that have not been acknowledged yet.
Configuration depending on notification type
UIn the "Mode" columnU:
“Do not send”: used for suspending sending certain types of alerts
“Send and Forget”: standard SNMP mode, no acknowledgement awaited, notifications are
destroyed immediately after sending.
“Resend until acknowledged”: standard alarm mode. Notifications are re-transmitted until
acknowledgement reception. The acknowledgement mode depends on the sending mode:
 automatic acknowledgement for sending with INFORM
 manual acknowledgement for Traps V1 and Traps V2c
! If “Resend until acknowledged” is selected, be aware that the number of traps sent may quickly overload
the memory. We therefore advise you to choose another mode.
Re-transmissions / Acknowledgment working principle
For the “Resend until acknowledged” mode, it is possible to set the maximum number of tries and
acknowledgment timeout.
As long as its acknowledgement has not been received, the notification is re-transmitted at the rate of one sending
every <d> seconds, for a maximum of <n> times; where <d> and <n> are respectively <Ack Timeout> and <Max
Retries> fields.